Caterpillar — Caterpillar 10-140 Construction Equipment Maintenance Manual

23 Safety Section Engine Stopping SEBU7645-06 Avoid any conditions that can lead to tipping the machine. The machine can tip when you work on hills, on banks and on slopes. Also, the machine can tip when you cross ditches, ridges or other unexpected obstructions. When you turn the battery disconnect switch to the OFF position, you can avoid battery discharge due to the following causes: e battery short circuit Avoid operating the machine across the slope. When ¢ current draw via some components possible, operate the machine up the slopes and down the slopes. e vandalism Maintain control of the machine. Do not overload the machine beyond the machine capacity. Never straddle a wire cable.

Never allow other personnel to straddle a wire cable. Know the maximum dimensions of your machine. Always keep the Rollover Protective Structure (ROPS) installed during machine operation. 102624835 Engine Stopping SMCS Code: 103745198 Slope Operation SMCS Code: 7000 Machines that are operating safely in various applications depend on these criteria: the machine model, configuration, machine maintenance, operating speed of the machine, conditions of the terrain, fluid levels, and tire inflation pressures. The most important criteria are the skill and judgment of the operator.

A well-trained operator that follows the instructions in the Operation and Maintenance Manual has 1000; 7000 Do not stop the engine immediately after the machine has been operated under load. This can the greatest impact on stability. Operator training provides a person with the following abilities: observation of working and environmental conditions, components. feel for the machine, identification of potential hazards, and operating the machine safely by making appropriate decisions. After the machine is parked and the parking brake is engaged, allow the engine to run for two minutes before shutdown. This allows hot areas of the engine to cool gradually.

© When you work on side hills and when you work on slopes, consider the following important points: cause overheating and accelerated wear of engine Speed of travel — At higher speeds, forces of inertia , tend to make the machine less stable. i01665341 Parking SMCS Code: 7000 Park on a level surface. If you must park on a grade, chock the machine. Apply the service brake in order to stop the machine. Move the transmission control lever and the transmission direction control switch (if equipped) to the NEUTRAL position. Engage the parking brake. Lower all work tools to the ground. Stop the engine. Turn the engine start switch key to OFF position and remove the key.

Turn the key for the battery disconnect switch to the OFF position. Remove the key when you get off the machine for an extended period of time. Roughness of terrain or surface ~ The machine may be less stable with uneven terrain. Direction of travel — Avoid operating the machine across the slope. When possible, operate the machine up the slopes and operate the machine down the slopes. Place the heaviest end of the machine uphill when you are working on an incline. Mounted equipment — Balance of the machine may be impeded by the following components: equipment that is mounted on the machine, machine configuration, weights, and counterweights.

Nature of surface — Ground that has been newly filled with earth may collapse from the weight of the machine. Surface material — Rocks and moisture of the surface material may drastically affect the machine's traction and machine's stability. Rocky surfaces may promote side slipping of the machine.