24 Safety Section Work Tools SEBU7645-06 Slippage due to excessive loads — This may cause downhill tracks or downhill tires to dig into the ground, which will increase the angle of the machine. Do not exceed the maximum operating weight that is listed on the ROPS certification. If your machine is equipped with an extendable stick, Width of tracks or tires — Narrower tracks or narrower tires further increase the digging into the ground which causes the machine to be less stable. following work tools: hydraulic hammers, augers, and impiements attached to the drawbar — This may Always wear protective glasses. Always wear the decrease the weight on the uphill tracks.
This may protective equipment that is recommended in the work tool's operation manual. Wear any other aiso decrease the weight on the uphill tires. The decreased weight will cause the machine to be less stable. Height of the working load of the machine — When the working loads are in higher positions, the stability of the machine is reduced. Operated equipment ~— Be aware of performance features of the equipment in operation and the effects on machine stability. install the transport pin when you are using the compactors protective equipment that is required for the operating environment.
To prevent personnel from being struck by flying objects, ensure that all personnel are out of the work area. While you are performing any maintenance, any testing, or any adjustments to the work tool stay clear of the following areas: cutting edges, pinching surfaces, and crushing surfaces. Operating techniques — Keep ail attachments or pulled loads low to the ground for optimum stability. Machine systems have limitations on slopes Slopes can affect the proper function and operation of the various machine systems. These machine systems are needed for machine control. Never use the work tool for a work platform. 101329164 Equipment Lowering with Engine Stopped Note:
Safe operation on steep slopes may require special machine maintenance. Excellent skill of the operator and proper equipment.for specific applications are also required. Consult the Operation and Maintenance Manual sections for the proper fluid level requirements and intended machine use. 103562303 Work SMCS Tools Code: Before lowering any equipment with the engine stopped, clear the area around the equipment of all personnel. The procedure to use will vary with the type of equipment to be lowered. Keep in mind most systems use a high pressure fluid or air to raise or lower equipment.
The procedure will cause high pressure air, hydraulic, or some other media to be released in order to lower the equipment. 6700 Only use work tools that are recommended SMCS Code: 7000 by Caterpillar for use on Caterpillar machines. Work tools and work tool control systems, that are compatible with your Caterpillar machine, are required for safe machine operation and/or reliable machine operation. If you are in doubt about the compatibility of a particular work tool with your machine, consult your Caterpillar dealer. Make sure that all necessary guarding is in place on the host machine and on the work tool. Keep all windows and doors closed on the host machine.
A polycarbonate shield must be used when the host machine is not equipped with windows and when a work tool could throw debris. Wear appropriate personal protective equipment and foilow the established procedure in the Operation and Maintenance Manual, “Equipment Lowering with Engine Stopped” in the Operation Section of the manual.