Caterpillar — Caterpillar 10-140 Construction Equipment Maintenance Manual

55 SEBU7645-06 Operation Section Before Operation Operation Section 102363025 Daily Inspection Before Operation SMCS Code: 1000; 7000 A WARNING 102189821 Mounting and Dismounting Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact skin. SMCS Code: 7000 At operating temperature, the engine coolant is hot and under pressure. Steam can cause personal injury. Check the coolant level only after the engine has been stopped and the cooling system pressure cap is cool enough to touch with your bare hand. Remove the cooling system to relieve pressure. Illustration 26 g00037860 pressure cap slowly Cooling system conditioner contains alkali.

Avoid contact with the skin and eyes to prevent personal injury. Typical example Mount the machine and dismount the machine only at locations that have steps and/or handholds. Before you mount the machine, clean the steps and the handholds. Inspect the steps and handholds. Make all necessary repairs. Face the machine whenever you get on the machine and whenever you get off the machine. Maintain a three-point contact with the steps and with the handholds. Note: Three-point contact can be two feet and one hand. Three-point contact can also be one foot and two hands. NOTICE Accumulated grease and oil on a machine is a fire haz- ard.

Remove this debris with steam cleaning or high pressure water, at least every 1000 hours or each time any significant quantity of oil is spilled on a machine. Note: For maximum service life of the machine, make a thorough daily inspection before you operate the machine. Inspect the machine for leaks. Remove any debris from the engine compariment and the undercarriage. Ensure that all guards, covers, and caps are secured. Inspect all hoses and belts for damage. Inspect all lights and mirrors for damage. Note: If any leaks are noted on the axles, perform the oil level check. Refer to Operation and Maintenance Do not mount a moving machine. Do not dismount a moving machine.

Never jump off the machine. Do Manual, “Differential and Final Drive Oil Level Check” for the proper procedure to check the axles. not carry tools or supplies when you try to mount the machine or when you try to dismount the machine. Use a hand line to pull equipment onto the platform. Do not use any controls as handholds when you enter the operator compartment or when you exit the operator compartment. Make the needed repairs before you operate the machine. Perform the following procedures on a daily basis. « Operation and Maintenance Manual, “Backup Alternate Exit Machines that are equipped with cabs have alternate exits.

For additional information, see Operation and Maintenance Manual, “Aiternate Exit’. Alarm - Test” * Operation and Maintenance Manual, “Cooling System Level - Check” * Operation and Maintenance Manual, “Engine Oil Level - Check”