Caterpillar — Caterpillar 10-140 Construction Equipment Maintenance Manual

61 Operation Section SEBU7645-06 Machine Operation Heated Seat (If Equipped) The heating element for the heated seat is controlled by a thermostat. The thermostat opens the circuit for the heating element at 26.5° + 5°C (79.7° + 9°F). The thermostat closes the circuit for the heating element when the temperature drops below 15°C (59°F). The start switch key must be in the ON position for the heated seat to work. 1034415082 Seat Belt SMCS Code: 7327 g00932817 Iustration 44 Note: This machine was equipped with a seat belt when the machine was shipped from Caterpillar. At the time of installation, the seat belt and the instructions for installation of the seat belt meet 2.

To remove the slack in outer loop (1), rotate buckle (2). This will free the lock bar. This permits the seat belt to move through the buckle. the SAE J386 and ISO 6683 standards. See your 3. Remove Caterpillar dealer for all replacement parts. Always check the condition of the seat belt and the condition of the mounting hardware before you operate the machine. Seat Belt Adjustment the slack from the outer belt loop by pulling on the buckle. 4. Loosen the other half of the seat belt in the same manner. If the seat belt does not fit snugly with the buckle in the center, readjust the seat belt. for Shortening the Seat Belt Non-Retractable Seat Belts Adjust both ends of the seat belt.

The seat belt should be snug but comfortable. Lengthening the Seat Belt Illustration 45 g00100713 1. Fasten the seat belt. Pull out on the outer belt loop in order to tighten the seat belt. 2. Adjust the other half of the seat belt in the same Illustration 43 1. Unfasten the seat belt. g00100709 manner. 3. If the seat belt does not fit snugly with the buckle in the center, readjust the seat belt.