76 Operation Section Machine Operation SEBU7645-06 Security Management The MSS has the capability to allow you to program the system to automatically activate at different time periods with different keys. The MSS can also be programmed to reject a specific electronic key after a selected date and time. When you turn the key to the The transmission neutralizer is enabled when the switch is in the CENTER position. The transmission neutralizer defaults to the enabled position after the machine is started. Press the bottom of the switch in order to disable the transmission neutralizer. Press the top of the switch in order to enable the transmission neutralizer.
OFF position and the MSS is active, you have a 30 second interval in order to restart the machine with an unauthorized key. Also if the machine stalls, there is a 30 second interval for restarting the machine. This 30 second interval is counted from the time of turning the key to the OFF position. Note: Know your machine's settings because the use of an electronic key is no guarantee that the machine can be restarted. An expiration date can be set for each electronic key that is contained in the list of keys for the machine. The key will no longer start the machine when the internal clock in the security system passes the expiration date.
Each entry in the list of keys can have a different expiration date. Spare keys are available from your dealer. Before a key can operate the machine, the MSS must be set to accept that particular key. Contact your Caterpillar dealer for information on additional features of the MSS. Operator Programmable Transmission The service brakes will interrupt power to the transmission solenoids. This causes the transmission to be shifted into neutral. The brake pedal will also slow the ground speed of the machine. The service brake pressure that is needed to neutralize the transmission can be adjusted by the operator. The switch is a momentary switch in order to set the brake pressure.
Refer to the Operation and Maintenance Manual, “Programmable Transmission Neutralizer - Adjust” for information about adjusting the brake pressure. When the transmission is in the neutral position, this permits a faster engine speed. A faster engine speed creates a better hydraulic response. A better hydraulic response may be desired in order to raise the bucket while you position the bucket at the same time. Release the brake pedal in order to engage the transmission. Release the brake pedal in order to release the brake. Parking Brake Control Neutralizer NOTICE Do not engage the parking brake while the machine is moving unless the primary service brake fails.
The use of the parking brake as a service brake in regular operation will cause severe damage to the brake system. When the parking brake lever is engaged the transmission is neutralized. The machine will not move. Illustration 71 g00887347 Brake Pedals (1) — Use the left brake pedal or the right brake pedal to slow down the machine's ground speed for normal braking. Switching the direction control lever or the direction control switch (if equipped) from NEUTRAL to either direction will not cause the machine to move until the parking brake lever is disengaged.
Switching the direction control lever or the direction controi switch from either direction to NEUTRAL back to either direction may cause the machine to move while the parking brake lever is engaged. Refer to Operation and Maintenance Manual, “Braking System - Test” for more information. 930G Transmission Neutralizer Override Switch (2) — The switch overrides the transmission neutralizer. The light in the switch comes on when the transmission neutralizer is disabled.