77 Operation Section SEBU7645-06 Machine Operation NOTICE Moving the machine with the parking brake engaged can cause excessive wear or damage to the brake. If necessary, have the brake repaired before operating the machine. Note: If the direction control lever or the direction control switch (if equipped) is put in the FORWARD position or the REVERSE position before the parking brake is disengaged, then the machine will not move. Move the direction control lever or the direction control switch (if equipped) to NEUTRAL. Release the parking brake. Then, move the direction control Parking Brake — The parking brake lever is located on the left side of the seat.
Use the parking brake after the machine is stopped. Note: The following applies only to the 930G (S/N: TWR1-up; TFWV1-up). An elevated low idle strategy is used for the 930G when the parking brake is engaged. With the parking brake disengaged, the engine low idle will be elevated to 950 rpm. With the parking brake engaged, the engine low idle will be lever or the direction control switch (if equipped) to the desired direction in order for the transmission to be engaged. Secondary Brake — The secondary brake uses the same lever as the parking brake. If the service brakes fail to stop the machine, use the secondary brake. Quick Coupler Control lowered to 830 rpm.
The change in the engine idle will provide the following benefits: * When the parking brake is released, the change in the low idle prevents a low idle stall condition. « When the parking brake is engaged, the change provides improved fuel economy. — / 901395269 Illustration 73 Disengage — The switch has a locking tab. Pull the red button downward and press the lilustration 72 Parking Brake Engaged g00866050 bottom of the switch. Hold the switch in the downward position until the coupler pins disengage. — Pull up on the parking brake lever in order to engage the parking brake. The transmission will shift to neutral. The alert indicator for the parking brake will come on.
The alert indicator Engage << — Press the top of the switch and hold the switch for 3 seconds in order to . . engage the pins for the quick coupler. is located on the right side of the steering column. Visually ensure that both coupler pins are extending Parking Brake Disengaged — Push the button on the top of the parking brake lever. Lower the parking brake lever in order to release the parking brake. out of the holes in the work tool mounting bracket. Note: Operating instructions for specific work tools are not provided. The function of the control lever is dependent upon the installation of an Auxiliary Equipment Manufacturer's work tool. Reference:
Refer to the Operation and Maintenance Manual, “Operation Information” “Quick Coupler Function” topic for more information about the quick coupler.