85 SEBU7645-06 Operation Section Machine Operation Caterpillar may share some or ail of the collected Regulatory Compliance information with Caterpillar affiliated companies, dealers, and authorized representatives. Caterpillar will not sell or rent collected information to any other third party and will exercise reasonable efforts to keep the information secure. Caterpillar recognizes and respects customer privacy. For more information, please contact your local Caterpillar dealer. ORBCOMM TYPE APPROVAL: 801QWI IC: 4650A-Q121415 Operation in a Blast Site If the machine is required to work within 12 m (40 ft) of a blast site, then Product Link PL121SR must be disabled.
In order to disable theProduct Link PL121SR install a Product Link Disconnect Switch in the machine cab that will allow the Product Link PL121SR module to be shut off. Refer to Special Instruction, REHS2365, “An Installation Guide for the Product Link PL121SR and for the PL300” for more details and installation instructions. You may also disconnect the Product Link PL1271SR module from the main power source by disconnecting the wiring harness at the Product Link module. This blast site warning does not supersede the published requirements or regulations found in “Title 30 of the Code of Federal Regulations (CFR)”.
This warning does not allow deviation from the published CEe®@ IHustration 86 g01131982 NOTICE Transmission of information using Product Link is subject to legal requirements that may vary from location to location, including, but not limited to, radio frequency use authorization. The use of Product Link must be limited to those locations where ail legal requirements for the use of the Product Link communication network have been satisfied. the Code of Federal Regulations (CFR)”. A hazard assessment should be conducted by each customer.
Every customer should meet all of the requirements of “Title 30 of the Code of Federal Regulations (CFR)” in order to ensure the safe storage, transportation, loading, and blasting of any explosive. In the event that a machine outfitted with Product Link is located in or relocated to a location where (i) legal requirements are not satisfied or (ii) transmitting or processing of such information across multiple locations would not be legal, Caterpillar disclaims any and all liability related to such failure to comply and Caterpillar may discontinue the transmission of information from that machine.
The following Product Link PL121SR specifications are provided in order to aid in conducting any related that concern the operation of the Product Link in a hazard assessment and to ensure compliance with specific country. requirements or regulations found in “Title 30 of all local regulations: ¢ The transmit power rating for the Product Link PL121SR transmitter is five to ten watts * The operating frequency range for the Product Link PL121SR module is 148 MHz to 150 MHz. Consult your Caterpiliar dealer if there are any questions. Information for the initial installation of the Product Link PL121SR is available in Special Instruction, REHS2365, PL121SR’.
“Installation Guide for the Product Link Operation, configuration, and troubleshooting information for the Product Link PL121SR can be found in System Operation Troubleshooting Testing and Adjusting, RENR7917. Consult your Caterpillar dealer with any questions