Caterpillar — Caterpillar 10-140 Construction Equipment Maintenance Manual

84 SEBU7645-06 Operation Section Machine Operation Low idle must be set correctly. Adjust for tne high Machine Security System (18) (if Equipped) side of the Low Idle specification while the most often used electrical loads are turned on. In order to reduce the loads, use the Medium fan speed instead of the the light is green you can start the engine. If the light — If is red the engine will not start. High fan speed. 103555467 If this procedure does not cause the alert indicator to turn off, move to a convenient location. Investigate the cause (loose alternator belt, broken alternator Product Link (if Equipped) beit, damaged batteries, etc). SMCS Code:

7606 lf the engine speed is near operating speeds and if the electrical loads are light, the alert indicator may remain on. If the alert indicator remains on, move to a convenient location. Investigate the cause (loose alternator belt, broken alternator beit, damaged The Product Link PL121SR is a satellite communication device that transmits information regarding the machine to Caterpillar, Caterpillar dealers, and Caterpillar customers. The unit contains a Global Positioning System receiver (GPS receiver) batteries, etc). and a Transmission Oil Filter (10) — The transmission oil filter has been bypassed. The lamp will come on at start-up.

When the machine reaches normal operating temperature and the lamp does not turn off change your filter. © Axle Oil Pressure (11) — The alert indicator wiil light when the oil pressure in the axle oil cooler (if equipped) is low. If this alert indicator comes on, stop the machine immediately. Engage the parking brake and stop the engine. Investigate the cause. © © © © Right Turn Signal (12) The Product Link PL121SR is capable of two-way communication between the machine and a remote user. The remote user can be a dealer or a customer. At any time, a user can request updated information from a machine such as hours of use or the location of the machine.

Also, the system parameters for Product Link PL121SR can be changed. Data is transmitted from the machine to a satellite. Next, the data is transmitted to a ground station. The receiving station transmits the data to Caterpillar Inc. The data can then be sent to a Caterpillar dealer and to the customer. Data Broadcasts Machine data about the machine's condition and Work Lights (13) — The work lights are on. operation is being transmitted by Product Link to Caterpillar and/or Caterpillar dealers in order to better serve the customer and to improve Caterpillar products and services. The information that is High Beams (14) (if equipped) beams are on.

— The high Hydraulic Oil Filter Bypass (15) — The hydraulic oil filter has been bypassed. The iamp will come on at start-up. When the machine reaches normal operating temperature and the lamp does not turn off change your filter. ) ® satellite transceiver. Air Filter restriction (16) — The air filter is restricted. Check the air cleaner indicator and clean out the air filter. Ride Control (17) — The ride control is active. transmitted may include the following data: machine serial number, location of the machine, fault codes, emissions data, fuel usage, service meter hours, version numbers for software and hardware, and installed attachments.

Caterpillar and/or Caterpillar dealers may use this information for various purposes: providing services to the customer and/or the machine, checking or maintaining Product Link equipment, monitoring the machine's health or performance, heiping to maintain the machine, improving the machine's efficiency, evaluating or improving Caterpillar products and services, complying with legal requirements and valid court orders, performing market research, and offering the customer new products and services.