Caterpillar — Caterpillar 10-140 Construction Equipment Maintenance Manual

83 SEBU7645-06 Operation Section Machine Operation Level 2 — This warning level is used to indicate that the operation of the machine should be changed. Possible severe damage to components on the machine may occur. Level 2-Special — This warning level is used to Primary Steering Failure (3) — The alert indicator will light and the action alarm will sound when the primary steering flow is not functioning. The alarm will only sound when the engine is running. indicate that the operation of the machine should t Level 3 -— This warning level is used in order to indicate that the machine needs to have a safe emergency engine shutdown.

Possible injury to the operator or severe damage to components may occur. 6) The warning light may flash either red or yellow. Do not operate the machine until the cause has been corrected. as be changed as soon as possible. Possible severe damage to components on the machine may occur. on, stop the machine immediately. Engage the parking brake and stop the engine. Investigate the cause. As an automatic lamp test, all of the alert indicators Low Engine Oil Pressure (5) ©) will light when the engine start switch key is turned to the ON position. The lamps should stay on for three to five seconds. The action alarm should sound also.

If all of the alert indicators do not come on or if the action alarm does not come on, investigate the cause. Low Brake Pressure (4) — The alert indicator will light when the brake oil pressure is low. If this alert indicator comes — The alert indicator will light when the engine oil pressure is low. If this alert indicator comes on, stop the machine immediately. Stop the engine and investigate the cause. ) Action Lamp (6) — If the lamp comes on the machine needs to be serviced soon. If the lamp comes on and an action alarm © comes on stop the machine immediately. is warmed (P) Starting Aid (7) — Starting aid is active. This function is controlled automatically.

The indicator should go off after the engine up. Parking Brake (8) — The alert indicator will light when the parking brake is engaged. O oO 9 o ® Q. The alert indicator should come on during start-up when the parking brake is applied. The alert indicator should go out when the parking brake is Electrical System (9) -— The alert indicator will light when there is a malfunction in the electrical system. If this alert indicator INustration 85 (<) g00904717 Left Turn Signal (1) comes on, the system voltage is too high for normal machine operation or too low for normal machine operation.

lf electrical loads (air conditioning and/or lighting) are high and the engine speed is near idle, increase the 4[@) Secondary Steering (2) (If Equipped) — The alert indicator will light when the electrical secondary steering motor is active. Do not operate the machine until the cause has been corrected. engine speed to high idle. This will generate more output from the alternator. If the alert indicator for the electrical system turns off within one minute, the electrical system is probably operating in a normal manner. However, the electrical system may be overloaded during periods of low engine speeds.

Modify the operating cycle in order to prevent overloading the electrical system and discharging the batteries.