Caterpillar — Caterpillar 10-140 Construction Equipment Maintenance Manual

94 SEBU7645-06 Operation Section Adjustments 102185740 Programmable Transmission Neutralizer - Adjust SMCS Code: 4269-025 S/N: TWR1-Up SIN: TFW1-Up Illustration 97 g00887587 928G 3. Loosen the two bolts that clamp the switch (1) to the tube. Move the switch until the orange light (2) comes on. Move the switch down the cylinder in order to increase the digging angle. Move the switch up the cylinder in order to decrease the digging angle. Note: Do not adjust the work tool postioner by Illustration 98 g00887347 adjusting the tube assembly. 4. To test the adjustment, start the engine. Raise the bucket. Move the bucket tilt lever to the TILT BACK detent position. 5.

When the bucket reaches the preset digging angle, the bucket tilt lever should return to the HOLD position. The transmission neutralizer function puts the transmission in neutral when the brake pressure reaches the pressure setting. The transmission is held in neutral until the brake is released. The transmission neutralizer switch (2) is used to disable the transmission neutralizer function. The same switch is used in order to change the brake pressure of the transmission neutralizer function. The light on the transmission neutralizer switch is illuminated when the feature is disabled. Note: The bottom position is the DISABLED position. The center position is the ENABLED position.

The top is the SET position. Depress the top of the transmission neutralizer switch and release the top of the transmission neutralizer switch in order to display the current transmission neutralizer value on the instrument cluster. 1. Start the engine. 2. Depress the top of the transmission neutralizer switch longer than 3 seconds. The display on the instrument cluster displays the brake pressure. 3. Push on the service brake pedal (1) until the desired pressure is achieved. The pressure may be set to any level in the range of 400 kPa (58 psi) and 1999 kPa (290 psi). 4, Release the transmission neutralizer switch. 5. The switch will return to the center position.

The transmission neutralizer function will be enabled at the current brake pressure.