93 SEBU7645-06 Operation Section Adjustments Adjustments 101821584 Work Tool Positioner - Adjust 101727272 Lift Kickout - Adjust SMCS Code: 5112-025 SMCS Code: 5109-025 caution Use to avoid possible personal injury when adjusting the bucket positioner. Use caution to avoid possible personal injury Stop the engine and lower all equipment to relieve when adjusting the attachment lift kickout. the hydraulic pressure. Keep personnel off the machine. Clear the area when working under or around the attachment Engage the parking brake and block the tires to linkage. prevent sudden movement of the machine. Keep unauthorized personnel off the machine.
With the attachment raised, proper support must be provided for the attachment and/or the linkage. 4. Start the engine. Lower the bucket to the ground. 1. Start the engine. Raise the bucket to the desired 2. Position the bucket at the desired angle to the height and stop the engine. 2. Block up the bucket and the linkage. Illustration 94 ground. Turn the engine start switch key to the OFF position and remove the engine start switch key. Move the bucket tilt lever to the TILT BACK detent position. g00103806 Typical Example lllustration 95 g00612503 924Gz 3. Loosen the magnet clamp. Align the magnet with the switch assembly. 4.
To increase the lift kickout height for the bucket, move the magnet counterclockwise. To decrease the lift kickout height for the bucket, move the magnet clockwise. 5, Tighten the magnet clamp. 6. Start the engine. To check the adjustment, move the bucket lift lever to the RAISE detent position. 7. When the bucket reaches the preset lift height, the bucket lift lever should return to the HOLD position. Illustration 96 924G/IIT28G Typical Example g00612564