92 SEBU7645-06 Operation Section Operation 9. Back up the machine and make sure that there is no movement between the work tool and the coupler. Steps 7 through 9 indicate that the coupler pins have fully engaged into the retainer holes for the work tool. Work Tools That Require Hydraulics Follow the procedure that is described in Operation and Maintenance Manual, “Front Work Tool Coupler for Tools That Do Not Require Hydraulics”.
g00104402 Illustration 92 Auxiliary quick connectors for fourth valve function IT28G Iustration 90 g00641175 Quick disconnect fittings for the third valve operation 924G g00921719 Illustration 93 Auxiliary quick connectors for the IT28G Before you connect the quick disconnect plugs or before you disconnect the quick disconnect plugs, follow the steps below. ¢ Stop the engine. e Move all of the control levers for the work tool in order to relieve the pressure in the hydraulic lines. Hlustration 91 g00641249 Quick disconnect fittings for the fourth valve operation 924G ¢ Return all of the levers to the HOLD Disconnecting position.
Lines ¢ Disconnect the hydraulic lines of the tool that will be used. Wipe off all foreign material. « Install plugs on any unused connectors.