91 Operation Section Operation SEBU7645-06 Make any necessary repairs before you return the machine to operation. Quick Coupler Equipped) Function (if Disengaging the coupler pins will release the work tool from control of the operator. Serious injury or death may result from disengaging the work tool when it is in an unstable position or carrying a load. Place the work tool in a safe position engaging the coupler pins. Illustration 89 g00886474 (1) Secondary Steering is activated. (2) Primary Steering has failed. (3) Secondary Steering Switch The primary steering indicator (2) indicates that the primary steering has failed. The alarm will also sound when the engine is running.
The secondary steering indicator (1) indicates that the secondary steering system is activated. Push the secondary steering switch (3) to the ON position and hold the secondary steering switch in the ON position in order to articulate the machine when the machine is stopped. Push the secondary steering switch to the ON position and hold the secondary steering switch in the ON position in order to articulate the machine when the machine is being towed. Push the secondary steering switch in order to determine if the secondary steering and the alert indicator are functional. When the alert indicators come on, steer the machine immediately to a convenient location and stop the machine.
Stop the engine and investigate the cause. Do not operate the machine until the cause has been corrected. Note: If the hydraulic system functions are used at low engine speeds, the alert indicator may come on momentarily. before dis- Front Work Tool Coupler for Tools That Do Not Require Hydraulics 1. Slide the red button backward and push down on the top of the quick coupler pin switch in order to disengage the coupler pins. 2. Tilt the coupler assembly forward. Make sure that the coupler assembly is below the level of the hooks on the work tool that will be attached. 3. Slowly, drive the machine forward. Align the hooks on the work tool with the coupler assembly.
4, Pull back on the lift lever in order to slightly raise the coupler. Raise the coupler until the coupler assembly contacts the hooks on the work tool and the work tool is lifted up slightly. Make sure that the work tool is level from one side to the other side. 5. Tilt back the coupler assembly until the alignment bar of the work tool contacts the coupler. 6. Press the top of the switch and hold the switch for 3 seconds in order to engage the pins for the quick coupler. Note: Visually ensure that both coupler pins are extending out of the holes in the work tool mounting bracket. Ensure that the tool is firmly attached and continue with steps 7 through 9. 7.
Push the tilt lever in order to tilt the work tool downward. 8. Push the lift lever forward in order to put down pressure on the work tool.