Caterpillar — Caterpillar 10-140 Construction Equipment Maintenance Manual

90 SEBU7645-06 Operation Section Operation Operation Changing from iow speed to high speed ait full engine speed is possible. Directional changes at full engine speed are possible. However, if you are changing 103001287 Operation Information SMCS direction, reducing the machine speed and/or braking the machine is recommended. This will provide operator comfort and the maximum service life of the Code: 7000 To prevent injury, make sure that no people are working on the machine or near the machine. To prevent injury, keep the machine under control at all times. Reduce engine speed when you maneuver in tight quarters or when you are going over a hill. power train components.

Keep a loaded bucket low to the ground. Stop the machine in order to avoid an unstable machine. 1. Lower the engine speed with the governor pedal. 2. Push the brake pedals (2) downward in order to slow the machine. Push the brake pedals (2) downward in order to stop the machine. downhill. 3. Move the transmission direction control lever (1) or move the direction control switch (3) (if equipped) to the desired direction. Rotate the transmission lever to the desired speed. When you go downgrade, use the same gear speed 4. Release the brake pedals. Select the necessary gear speed before you start downgrade. Do not change gears while you are going that would be used to go upgrade.

Do not allow the engine to overspeed when you go downhill. Use the service brake pedal to reduce engine overspeed when you are going downhill. When the load will be pushing the machine, put the transmission selector lever in FIRST speed before you start downhill. Changing Direction and Speed 5. Increase the engine speed with the governor pedal. Secondary Steering (If Equipped) The purpose of the secondary steering system is providing steering control if the following conditions are met. * The engine has been started and the start switch key is in the ON position. ¢ The steering oil pressure is low or the steering oil pressure is not available.

The secondary steering indicator will come on for three seconds when the engine start switch key is in the ON position. During this time, the operator can determine if the pump motor for the secondary steering is engaged and the operator should try to steer the machine. lf the alert indicator does not come on or you are unable to steer the machine, do not operate the machine. Correct the cause of the failure before you operate the machine again. The secondary steering indicator will come on and the electric pump motor will activate when the secondary steering control senses a lack of oil pressure.

IHustration 88 (1) Transmission Direction Control Lever (2) Service Brake Pedals (3) Transmission Direction Control Switch (If Equipped) 900886442 The secondary steering system will be deactivated when oil pressure has returned to the system. If the primary steering indicator comes on and/or the action alarm sounds, steer the machine to a convenient location and stop the machine.