Caterpillar — Caterpillar 10-140 Construction Equipment Maintenance Manual

96 Operation Section Parking SEBU7645-06 Parking Stopping the Engine if an Electrical Malfunction Occurs i01696079 Stopping the Machine SMCS Code: 1000; 7000 SMCS Code: 7000 Turn the engine start switch key to OFF. If the engine does not stop, perform the following procedure. NOTICE Park on a level surface. If it is necessary to park ona 1. Open the engine access door that is located on the right side of the machine. grade, block the wheels securely. Engage the parking brake. Do not engage the secondary brake while the machine is moving unless the primary service brakes fail. 1. Apply the service brakes in order to stop the machine. 2.

Move the transmission control lever and the transmission contro! switch (if equipped) to the NEUTRAL position. 3. Engage the parking brake. 4. Lower the work tooi to the ground and apply slight downward pressure. g00915144 Illustration 99 2. Pull outward on the connector that is located on the solenoid for the fuel pump. Stopping the Engine. SMCS Code: 1000; 7000 NOTICE Stopping the engine immediately after it has been working under load, can result in overheating and accelerated wear of the engine components. Refer to the following procedure, to allow the engine to cool, and to prevent excessive temperatures in the turbocharger housing (if equipped), which could cause | Note:

Do not operate the machine again until the malfunction has been corrected. 101696164 Equipment Lowering with Engine Stopped SMCS Code: NTs oil coking problems. 1. Operate the engine for five minutes at low idle with no load. This allows hot areas in the engine to cool gradually. This will extend the engine life. 2. Turn the engine start switch key to the OFF position in order to stop the engine. 3. Move all hydraulic contro! levers back and forth in order to relieve hydraulic pressure. 4. Move ali hydraulic control levers into the HOLD position. 7000 Personal injury or death can result from boom iowering. The boom can drop when lowering it with the engine stopped.

Keep all personnel away from the boom drop area when lowering the boom with the engine stopped. Be sure no one is under or near the front linkage before manually lowering the boom.