Replica 1 plus Users Manual Under Serial Port options, the new BAUD rate for the replica 1 is the default 9600, 1 stop bit, no parity, and no flow control. Change the msec/char from 0 to 50 and the msec/line to 200. This keeps proper delays so no data loss should happen. Click OK to finish this section. Figure 13: Serial Port Configuration window Next click Setup again and this time select Terminal. On the terminal page, under New-line Receive: change the value to CR+LF so a new line is created on ENTER. Click OK and you are ready. Figure 14:
Tera Term terminal setup screen Press RESET on your replica 1 and make sure the CAPS LOCK is on your PC and type something and see if what you type appears on the serial screen. If you have followed the steps correctly, you now have a connection to your PC with the replica 1. © Briel Computers 2014 page 24