Replica 1 plus Users Manual Transferring files with Tera Term To send a file to your replica, simply click on the File tab, select “Transfer” then select “Send Text File” from the drop down list. Figure 18: Send text file Find the file on your PC and select “OK”. At this point Tera Term will send the file your replica and your replica will treat the file as if you were typing it in. Once it is finished typing in, just run your program as normal. Remember, if you are sending a BASIC file to enter BASIC by typing “E000R” followed by “Enter” before sending the file. Some files included will start for you automatically. To receive a file is just as easy.
Once again, click on the File tab, but this time select “Log” from the drop down list. This will bring up a file name to save option and select the name for your file. Select “OK” to begin the “Capture” mode. If you’re in BASIC you can type LIST and Hyper Terminal will capture your BASIC listing. If you’re in the Woz monitor, simply type the address range to capture, followed by “Enter.” Figure 19: Creating a log © Briel Computers 2014 page 25