Komatsu — 24.1 INITIAL 250 HOURS SERVICE (ONLY AFTER THE FIRST 250 HOURS)

24. SERVICE PROCEDURE 24.3 CHECK BEFORE STARTING 24.3.1 CHECK COOLANT LEVEL, ADD COOLANT 1. Open the rear door on the left side of the machine and check that the coolant level is between the FULL and LOW marks on radiator re- serve tank a (shown in the diagram on the right). If the coolant level is low, add coolant through the filler of reserve tank a to the FULL level. 2. After adding coolant, tighten the cap securely. 3. If the reserve becomes empty, first inspect for coolant leaks and then fill the radiator and the reserve tank with coolant. 24.3.2 CHECK OIL LEVEL IN ENGINE OIL PAN, ADD OIL 1. Open the engine hood on the machine. 2. Remove dipstick G and wipe the oil off with a cloth. 3.

Insert dipstick G fully in the oil filler pipe, then take it out again. 4. The oil level should be between the H and L marks on dipstick G . If the oil level is below the L mark, add engine oil through oil filler F . For details of the oil to use, see “20. USE OF FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE”. PC450-ENG 3-47 WARNING Do not open the radiator cap unless necessary. When check- ing the coolant, always check the radiator reserve tank when the engine is cold. WARNING The turbocharger (with safety cover) exhaust manifold is near dipstick G, so be careful not to touch it.