Komatsu — 24.1 INITIAL 250 HOURS SERVICE (ONLY AFTER THE FIRST 250 HOURS)

24. SERVICE PROCEDURE 24.6.5 CHECK FAN BELT TENSION, ADJUST Checking The belt should normally deflect by about 10 mm (0.39 in) when pressed with the finger (with a force of approx. 6 kg (13 lb) at a point midway between the alternator pulley and fan pulley. Adjusting 1. Loosen nuts and bolts a , b and c . 2. Turn nut d clockwise and move alternator e so that the deflection of the belt is approx. 10 mm (at approx. 6 kg (13 lb)). 3. Tighten nuts and bolts a , b and c to secure alternator e in posi- tion. 4. Check each pulley for damage, wear of the V-groove, and wear of the V-belt. In particular, be sure to check that the V-belt is not touching the bottom of the V-groove. 5.

Replace the belt if it is elongated and can no longer be adjusted, or if it is cut or cracked. 6. When the V-belt has been replaced, operate the machine for one hour, then adjust the belt tension again. PC450-ENG 3-60