24. SERVICE PROCEDURE 24.6.6 CHECK, ADJUST TENSION OF AIR CONDITIONER COMPRESSOR BELT Testing The belt should deflect 14 - 16 mm (0.55 - 0.63 in) when pressed with a finger force of approx. 6 kg (13 lb) at a point midway between the crank- shaft pulley and the compressor pulley. Adjusting 1. Loosen 2 bolts a and 2 bolts b , and move compressor c to adjust. 2. When the deflection is correct, tighten bolts a and b to hold the compressor in position. 3. Check each pulley for damage, and check the V-groove and V-belt for wear. In particular, check that the V-belt is not contacting the bottom of the V-groove. 4.
If the V-belt is stretched and cannot be adjusted any further, or if there are any cuts or cracks, replace the V-belt. 5. After replacing the V-belt, adjust again after one hour of operation. PC450-ENG 3-61