Komatsu — 24.9.7 CHECK VIBRATION DAMPER

24. SERVICE PROCEDURE 24.9.3 CLEAN ENGINE BREATHER 1. Wipe away dust around the breather. 2. Loosen the clamp and remove the hose. Remove breather a . 3. Clean the breather body with light oil or cleaning oil. 4. Replace O-ring with new one. Coat a new O-ring with engine oil, set it, then install breather a . 5. Check the breather hose. If caked oil (sludge) adheres to the inside, replace the hose with a new one. 24.9.4 CLEAN, CHECK TURBOCHARGER Contact your Komatsu distributor for cleaning or inspection. 24.9.5 CHECK ALTERNATOR, STARTING MOTOR The brush may be worn, or the bearing may have run out of grease, so contact your Komatsu distributor for inspection or repair.

If the engine is started frequently, carry out inspection every 1000 hours. 24.9.6 CHECK ENGINE VALVE CLEARANCE, ADJUST As special tool is required for removing and adjusting the parts, you shall request Komatsu distributor for service. 24.9.7 CHECK VIBRATION DAMPER Check that there are no cracks or peeling in the outside surface of the rubber a . If any cracks or peeling are found, contact your Komatsu distributor to have the parts replaced. PC450-ENG 3-73