24. SERVICE PROCEDURE 3. Bleeding air from cylinders 1. Run the engine at low idling, and extend and retract each cylinder 4-5 times. Do not operate the cylinder to the end of its stroke. Stop at a point approx. 100 mm before the end of the stroke. 2. Next, operate each cylinder to the end of its stroke 3-4 times. 3. After this, operate each cylinder 4-5 times to the end of its stroke to completely bleed the air. NOTICE If the engine is run immediately at high speed or the cylinder is operated to the end of its stroke, the air inside the cylinder may cause damage to the piston packing. 4.
Bleeding air from swing motor (Carry out this operation only when the oil in the swing motor case has been drained.) 1. Run the engine idle at a low speed for about five minutes, then loosen drain port plug a and confirm that oil flows out. NOTICE When doing this, do not operate the swing. 2. If oil does not flow out, stop the engine and fill the motor case with hydraulic oil through drain port plug a . 3. After completion of the air bleed operation, tighten drain port plug a . 4. Run the engine at low idling, and swing the upper structure at least 2 times uniformly to the left and right. NOTICE If the air is not bled from the swing motor, the bearings of the motor may be damaged.
PC450-ENG 3-77