. MAINTENANCE SERVICE PROCEDURE WHEN REQUIRED CLEAN INSIDE OF COOLING SYSTEM WARNING *1: When using Komatsu Supercoolant (AF-NAC), there is no need to use a corrosion resistor. When no corrosion resistor is used, use the special cover (600-411-9000). Please consult your Komatsu distributor about the method of installing. When using corrosion resistor, use Komatsu genuine corrosion resistor. If you use another corrosion resistor, it may cause serious problems such as corrosion of the engine and parts of the cooling system that use light metals such as aluminum. The coolant has the important function of preventing corrosion as well as preventing freezing.
Even in the areas where freezing is not an issue, the use of antifreeze coolant is essential. Komatsu machines are supplied with Komatsu Supercoolant (AF-NAC). Komatsu Supercoolant (AF-NAC) has excellent anticorrosion, antifreeze and cooling properties and can be used continuously for 2 years or 4000 hours. As a basic rule, we do not recommend the use of any coolant other than Komatsu genuine supercoolant (AF-NAC). If you use another coolant, it may cause serious problems such as corrosion of the engine and parts of the cooling system that use light metals such as aluminum.
To maintain the anticorrosion properties of Supercoolant (AF-NAC), always keep the density of Supercoolant between 30% and 68%. When deciding the ratio of antifreeze to water, check the lowest temperature in the past, and decide from the mixing table given below. It is actually better to estimate and temperature about 10 ° C (18 ° F) lower when deciding the mixing ratio. The mixing ratio depends on the ambient temperature, but it should always be a minimum of 30% by volume (antifreeze/total amount of coolant x 100). Even in areas where it is not necessary to prevent freezing, use Supercoolant (AF-NAC) at a mixing ratio of at least 30% to prevent corrosion of the cooling system.
4 - 20 Immediately after the engine is sto pped, the coolant is at a high te mperature and th e radiator is under high i nternal pressure. If the cap is remov ed to drain the co olant in this condition , there is a hazard of burns. Wait for the temperature to go down, then turn t he cap slow ly to release the p ressure before removing it. Clean ing is carrie d out with the eng ine running. When s tanding up or leaving the op erator's sea t, set the wor k equipment lock lever and the park ing lever to the L OCK position. For de tails of star ting the engine, s ee "CHECK BEFORE STARTIN G ENGINE, ADJU ST (PAGE 3 -94)" and "STARTING ENGINE (PAG E 3-117)" in the OPERATION s ection.
when the engine is running.There is danger of touching the fan. Never walk in fron t of the machine when the engine is r unning.Th ere is dang er of t ouching the fan. It is ex tremely dan gerous to go und er the machine to clea n it when the engine i s runn ing. There i s danger that the machine may sudde nly move. Never go under th e machine when the engine is running .
Stop th e machine on level ground when cleaning or changing the Clean th e inside o f the cooling sy stem, change the c oolant a ccording t o the t able below Int Antifreeze coolant erval for cleaning inside of cooling system and changing antifreeze coolant Precautions for use Komatsu supercoolant (AF-NAC) Every two years or every 4000 hours whichever comes first 1*