. MAINTENANCE SERVICE PROCEDURE of below -15 ° C (5 ° F). Mixing rate of water and antifreeze Min. atmospheric temperature ° -40 -40 Amount of antifreeze 62.1 16.41 Amount of water 44.9 11.86 WARNING NOTICE other than Komatsu genuine supercoolant. consult your Komatsu distributor. bottom of the radiator. idling to raise the When carrying out 8. To bleed the air mixed idling for 5 minutes, idling. 9. Drain the coolant sub-tank (5), then add marks. 4 - 21 f undiluted antifreeze is -15°C (5° F).
Do n ot store undiluted an tifreeze at a temperature C -10 -15 -20 -25 -30 -35 F 14 5 -4 -13 -22 -31 ter 32.1 38.5 42.8 49.2 53.5 57.8 gal 8.48 10.17 11.31 13.00 14.13 15.27 ter 74.9 68.5 64.2 57.8 53.5 49.2 gal 19.79 18.10 16.96 15.27 14.13 13.00 o be particularly careful to keep it aw ay from fl ame. coolant on yourself. removing the drain plug, be careful n ot to get your eyes immediately with ample wa ter, then consult a doctor for tre upercoolant (AF-NAC) for the coolant. As a basic rule,we do not recom mend the use of any coolant upercoolant. ute the coolant. If river water or w ell water or a simple water sup ply must be used, please ibutor.
a super coolant density meter to control the mixing ratio. ator water filler slowly. the coolant under drain valve (4) at the nd drain the water. nt, close drain valve (4), and fill with city or is full, start the engine and run at low erature to at least 90°C (194°F), then rox. 10 minutes. drain valve (4), and drain the water. r, clean the radiator with detergent. the flushing operation, follow the the flushing agent. nd add water to near the mouth of the water filler. in the coolant, run the engine at low en run for a further 5 minutes at high e the water filler cap off.) ide sub-tank (5), flush the inside of water to between the FULL and LOW or approx.
3 minutes, then add water to water filler and tighten cap (3). a super coolant density meter to control t