PACCAR 270 — 3. Remove the release stud assembly from the side pocket, and remove the release nut and washer f...

safe means to prevent rolling before manually releasing the spring brakes. To move a vehicle immobilized by the spring brakes due to loss of air pres- sure in the brake system, perform the following procedure: 1. Block the wheels with chocks. 2.Remove the cap from the spring chamber. 3. Remove the release stud assembly from the side pocket, and remove the release nut and washer from the release stud. WARNING! Do not disas- semble a spring brake cham- ber. Th ese chambers contain a powerful spring that is compressed. Sudden release of this spring can cause you to be severely injured. Do not operate a vehicle when the spring brakes have been manually released.

Driving a vehicle after its spring brakes are manually released is extremely dangerous. You will probably have no brakes at all. You could have a serious or fatal accident. Releasing the spring brakes on an unsecured vehicle could lead to an accident. The vehicle could roll, causing severe injury. Always secure the vehicle with wheel chocks, chains, or other WARNING! Do not drive vehicle with malfunctioning brakes. If one of the brake circuits should become inoperative, braking dis- tances will increase sub- stantially and handling characteristics while brak- ing will be affected. You could lose control of your vehicle, be severely injured, or cause an accident.

Have it towed to the nearest dealer or qualified workshop for repair. You may sometimes have to release your vehicle’s spring brakes by hand. This could happen if the system air pressure does not reach operating pressure because your engine or com- pressor is not working properly. You will have to release the spring brakes at the spring brake chambers. Emergency repairs