PACCAR 270 — Jacking The Vehicle

Emergency repairs WARNING! If you are not f ully qualified and not equipped with the proper tools and equipment, do not attempt to raise the vehicle or remove or install a damaged tire and wheel assembly. Obtain expert help. A per- son can be seriously injured and/or damage can result from using the wrong service methods. Truck tires and wheels should be serviced only by trained personnel using proper equipment. Before attempting to jack the vehicle, ensure the following: The complete vehicle is on stable level ground. The parking brake is applied and chocks have been positioned under the road wheels. Jacking The Vehicle 6. Assemble the release stud washer and nut on the release stud. 7.

With a wrench, turn the release stud assembly nut until the com- pression spring is 90–95 per- cent caged. While doing this, check to make sure the push rod (adapter push rod or service push rod) is retracting. Do not over-torque the release stud assembly. (S–Cam type maximum: 50 ft-lb.) The spring brake is now mechani- cally released. 4. Slide out the release stud. 5. Insert the release stud through the opening in the spring chamber where the cap was removed. Insert it into the pressure plate. Turn the release stud 1/4 turn clockwise in the pressure plate. This secures the cross pin into the cross pin area of the pres- sure plate and locks it into the manual release position.