PACCAR 270 — 4. Lightly depress and then remove the bulb from the bulb holder.

3. Lower cover and snap tabs back in place. 1. Remove the two screws and then detach the turn signal light assem- bly. 2. Release the protective rubber cover from the bulb holder. 3. Rotate the bulb holder counter- clockwise and detach from the turn signal lamp assembly. 4. Lightly depress and then remove the bulb from the bulb holder. Turn signal, front 4. Remove the sheet metal nut and carefully pry marker light off adhe- sive-backed foam. 5. If necessary, replace adhesive- backed foam pad. 6. Replace marker light. 7. Replace tie wraps. 1. Find the tab on the yellow lens. Using a narrow blunt tool, such as a flat screwdriver, pry off the lens using a gentle twisting motion. 2. Change bulb.

3. Replace lens. 1. Locate the two tabs at the bottom of the housing. Pop open (down). 2. Lift outer cover and remove sealed lamp and install new one. Rear Lights Side Lights NOTE: Marker light is a sealed assembly and must be replaced as a unit; the bulb alone cannot be replaced. 1. Remove two torx head screws (1). 2. From behind side marker light assembly, clip tie wraps. 3. Pull assembly out and carefully remove the two inline connections (2) by pulling them apart. Emergency repairs Side Marker Lights 1 2