PACCAR 270 — Front Marker Lights

Emergency repairs 6. Remove two center screws from the step plate in the center of the headlight grille. 7. Remove the headlight grille. 8. Remove four screws holding the headlight bezel in place and remove the headlight. 9. Replace the headlight and bezel. 10. Reverse the disassembly proce- dure and assemble all removed parts. Be sure to replace tie straps. Reach behind bumper and apply pressure to one side of light. This will cause the light assembly to pop out. Disconnect and replace. NOTE: Marker light is a sealed assembly and must be replaced as a unit, the bulb itself cannot be replaced. Front Marker Lights Hoist the vehicle at the rear end and engage the steering lock. 1.

Remove four Torx head screws from the side marker light assem- blies. There are two on each side of the headlight grille. 2. From behind the side marker lights, cut tie straps. 3. Pull assembly out and carefully remove the two inline connections on each side by carefully pulling them apart. 4. Remove four bolts from the front of the headlight grille, two on each side. 5. Remove two nuts from the back of the headlight grille. Replacing Bulbs Headlights WARNING! Do not attempt to tow the vehicle when it is fully laden. If the engine will not run, there will be no power assist to the steering and no air supply for the brakes.

Ensure that the steering lock of the towed vehicle is disengaged (unless the vehicle is being towed with its front wheels hoisted clear of the road). To prevent possible damage to the transmission, the driveshaft must always be disconnected at the dif- ferential. If there is insufficient pressure in air reservoirs, release the parking brake as stated earlier in this sec- tion). Being towed by another vehicle: If the differential is damaged: