PACCAR 270 — Towing

in position within the bumper through turning and allowing locking pin to move into retaining slot. The towing pin is suitable for all normal towing opera- tions. Ensure that the towing pin is secured in position. To check, attempt to lift pin vertically. It should not lift out. When installed correctly, the towing pin should protrude through the bottom aperture plate (2), and allow a vertical movement of no more than Ѕ inch when lifted. If the vehicle requires towing, it is rec- ommended that a suitable suspended towing procedure is employed.

Towing This is also why the maximum permit- ted difference in tire diameter for new tires is 7.5% (this may occur when dif- ferent tire sizes are installed on the front and rear axles). The front bumper incorporates a towing pin (1) that is fitted to the aperture of the bumper. The towing pin is secured Towing Pin 1 2 large (caused, for example, by a differ- ence in tread depths and/or tire pres- sures). The ABS is not designed to deal with excessive differences of this nature, as a result the system will disengage and the ABS warning light will illuminate.

Dependent upon the type of tires fitted to the front and rear axles, this problem may occur with a worn tire which is under-inflated by approx 29 psi. Conse- quently, if the ABS warning light illumi- nates after a wheel/tire change, always check the tire pressure before checking anything else. This means that in extreme condi- tions the ABS will no longer operate! Emergency repairs