Emergency repairs WARNING! Tighten wheel nuts properly. If they are not tightened properly, wheel nuts could eventually cause the wheel to become loose, to fail, and/ or to come off while the vehicle is moving, possibly causing loss of control and/or personal injury or damage to the vehicle. After the vehicle travels about 50 to 100 miles (80 to 160 km), wheel mountings “seat in” and will lose some initial torque. Check hub/wheel mountings after this initial period and retighten. If any wheel bolt(s) need replacing, all the bolts of the same wheel MUST be replaced. After changing a wheel, the difference in tire diameter between the various wheels on the vehicle may then be too WARNING!
Grooves in the wheel disc or other damage to the disc can lead to a seri- ous accident. The disc will be weakened and can even- tually come off, maybe caus- ing you to lose control of your vehicle. Be sure to use the right components and the right tools. The end of the wheel wrench must be smooth. Burrs on the end of the wrench can tear grooves in the disc, especially on aluminum wheels. These grooves may lead to cracks in the disc, and can cause it to fail. When installing the rear wheels, ensure that the tire inflation valves are opposed 180° to each other to facilitate tire infla- tion and aid tire balance. 6.
Install the wheel and gradually tighten the wheel nuts in a criss- cross sequence to 450 to 500 lb. ft. (610 to 680 Nm). Crisscross torque sequence for disc wheels