PACCAR 270 — Engine Fan and Shroud

Emergency repairs Noise and Emission Control WARNING! Do not work on the fan with the engine run- ning. The engine fan can engage at any time without warning. Anyone near the fan when it turns on could be seriously injured. Before turning on the ignition, be sure that no one is near the fan. Check all fasteners for tightness. Check for stress cracks in the fan and shroud. Make sure the shroud is adjusted so that it does not touch the fan blades. Check fan blade mounting bolts. Inspect fan blades to be sure they are not cracked or bent. If problems exist, refer to the Cooling System section in the maintenance manual for detailed maintenance instruc- tions.

– 105 – Engine Fan and Shroud charged engines, check joints at flanges and mounting brackets for tightness. Check muffler, clamps, and mount- ing brackets. Tighten if necessary. Inspect muffler for signs of rust or corrosion. Check internal baffling. You can do this by listening for rattling sounds while tapping the muffler with a rub- ber mallet or revving the engine up and down through its normal oper- ating range. Check the mounting. Tighten as necessary. Do not modify the end of the pipe in any way. Exhaust Tail Pipe Mufflers Check exhaust manifold cap screws for tightness, including those at the flanges.

Refer to the engine manufacturer's service manual for proper tightening sequence and torque values. Check for leaks, and tighten as necessary. Check for deterioration or dents in pipes and clamps which could allow exhaust to escape. Check exhaust piping for rust, cor- rosion, or damage. Replace deteri- orated piping before holes appear. If piping is perforated at any point, temporary patching or lagging is acceptable until you can have per- manent repairs made. On turbo- Joints and Clamps Piping