Starting Procedure Driving Your is equipped with either a manual, automatic, or automated manual trans- mission with special features and gear- ing to meet your particular needs. It is important for you, the driver, to under- stand how your particular transmission is operated. In addition to the instructions listed in this Operator’s Manual, additional instructions and guidelines are avail- able in the transmission manufacturer’s Driver/Operator’s Instruction Manual in your glovebox. Read the general guide- lines and instructions that follow and Operating the Transmission Introduction that adequate oil pressure is avail- able at the turbocharger bearings. 1.
Ensure that the parking brake is applied and the shift lever is in the neutral position. 2. Turn ignition key to position ‘C’ and check that the oil pressure and parking brake warning lights illumi- nate and that the fuel gauge shows sufficient fuel for the trip. 3. If the engine WAIT light is on, wait until it goes out. 4. With the accelerator pedal released, turn the ignition key to position D; release the key immedi- ately after the engine has started. If the engine fails to start after 10 seconds, release the key. Wait 10 seconds and repeat the starting procedure. WARNING! Ensure that the following safety instruc- tions are strictly observed:
Do not start the engine in a confined space or unventi- lated area. Exhaust fumes contain toxic gases which, if inhaled, can prove fatal. Before driving away, ensure that all warning lights have been extinguished and the warning buzzer has ceased to sound. CAUTION: When the engine starts and runs, do not allow the engine to exceed its idling speed for 10 seconds; this procedure will ensure Starting Procedure