Operating the Transmission Driving Putting the Vehicle in Motion WARNING! Never drive your vehicle with the parking brake ap plied. Always release the parking brakes prior to moving the vehicle. Failure to disengage the parking brakes prior to mov- ing your vehicle could result in excessive heat build-up in the brake system, resulting in a fire. NOTE: Today’s diesel elec- tronic engines have significant torque and startability power at low RPM. Combinations of engine speed and available torque may over-power the vehicle’s parking brakes. In cold weather [below 32°F (0°C)], you may find shifting sluggish when you first start up.
Transmission warm-up is especially important at this time, but it is always a good idea to warm your trans- mission oil before starting out on the road. To warm the transmission lubricating oil during engine warm-up: 1. Put the transmission in Neutral. 2. Release the clutch pedal and let the transmission operate in Neutral for three to five minutes prior to shifting into either a forward or reverse range. Transmission Warm–Up read the specific instructions contained in the transmission manufacturer’s Driver/Operator’s Instruction Manual. If your truck has an automatic transmis- sion, go to page 62 .
If your truck has an automated manual transmission, such as the Eaton® Auto- shift™, go to page 63 . Your transmission has six forward gears with full synchromesh engagement, and one reverse gear. You will find a shift pattern diagram on the gearshift knob. Make sure you follow the correct sequence for shifting your transmission. Operating Manual Transmissions