PACCAR 270 — Shifting Gears in a New Vehicle

Operating the Transmission Driving within optimum engine rpm, which is where maximum torque and power are obtained. Shift carefully in a new vehicle. The transmission may be a little stiff at first. Avoid gear clashing by closely following these procedures. When you are operating a new vehicle or one that has been exposed to cold weather, you want the transmission lubricant (fluid) to circulate and coat the contacting surfaces of the gears. Metal contacting metal in moving parts may seriously damage your transmission— do not drive in one gear for long periods of time until the transmission lubricant has a chance to coat all contacting sur- faces.

Shifting Gears in a New Vehicle you need to start up on an incline, apply your service brakes before you release the parking brake. Then release your service brakes as you engage the clutch and apply throttle. For further instructions on operating your transmission, see the transmission manufacturer’s Driver/Operator’s Instruction Manual. If you have a misaligned gear condition in your vehicle’s transmission and can- not start, gradually release the clutch, allowing the drive gear teeth to line up properly. Then the drive gear can roll enough to allow the teeth to line up properly and complete the shift.

The best engine performance and max- imum economy is obtained if gears are properly selected. This efficiency is achieved by always selecting gears CAUTION: Always use first gear or a low speed range to start the vehicle in motion. The use of a higher gear or speed range forces undue strain on the engine, clutch, other transmission compo- nents, and may cause dam- age. After making sure the vehicle’s oil and air pressure are correct and all other parts and systems are in proper work- ing condition: 1. Fully depress the clutch pedal and shift the transmission into first gear. 2. Lift the sleeve on the parking brake handle and push the handle fully forward to release the brakes. 3.

Release the clutch pedal, then gradually accelerate. 4. Do not allow your vehicle to roll (even a little) in the opposite direc- tion during clutch engagement. If