Brakes Driving on the service brakes. However, the engine exhaust brake is not an emer- gency brake. Ideally (on normal road surfaces), you should slow your vehicle with the engine exhaust brake (where permitted by law) and use the service brakes only for stopping completely. Operating this way will greatly prolong the life of the service brakes. WARNING! The service brakes must be used in an emergency. The engine exhaust brake alone might not stop you fast enough to prevent an accident. You could be badly hurt if you relied only on the engine exhaust brake. The engine exhaust brake is NOT intended as the primary brake for the vehicle, nor is it an emer- g en cy brake . The en gine WARNING!
Do not drive this vehicle with malfunctioning brakes. If one of the brake circuits should become inoperative, braking distances will increase substantially and handling characteristics while braking will be affected. You could lose control of your vehicle, be severely injured, or cause an accident. Have it towed to the nearest dealer or qualified work- shop for repair. An engine exhaust brake may be installed (as an option) to create a brak- ing effect on the drive wheels. This device uses your engine's power to slow your vehicle down.
Because it can help keep your vehicle's brakes from overheating, it can save wear and tear Engine Exhaust Brake (option) The parking brake control operates the spring brake actuators to apply the rear brakes on the vehicle. Move the control lever (1) fully rearward to apply the parking brakes; a locking sleeve (2) will lock the control lever in position. To release the parking brake, lift the locking sleeve and move the con- trol lever fully forward to the off position. A red warning light in the instrument panel will illuminate whenever the park- ing brake is applied; refer to the “Instru- ments and controls” section of this handbook.
In the event of a failure in the service brakes, the parking brake can be used as an emergency brake. Gradually move the parking brake control lever rearward to slowly apply the rear brakes on the vehicle. Braking effort will be proportional to the control lever move- ment.