PACCAR 270 — Exhaust Brake Operation

Brakes Driving Engine speed is greater than 1000 rpm WARNING! Do not use the engine exhaust brake when operating on road surfaces with poor traction (such as wet, icy, or snow covered roads or gravel). The engine exhaust brake can cause the wheels to skid on a slippery surface. You could lose control of the vehicle and/or jackknife if the wheels begin to skid, resulting in an accident. Your vehicle is equipped with Rockwell/ WABCO anti-lock brakes (ABS) and the operation of the engine exhaust brake (if turned ON) will be controlled by the ABS. For more ABS information, see “Anti-Lock Braking System (ABS)” on page 65 .

After the engine is started, warmed up, and you are ready to get under way, turn the exhaust brake switch ON for added braking effect. The engine exhaust brake activates if all of the following conditions are true: PTO and cruise control are inactive Clutch pedal is not depressed 0% throttle exhaust brake only helps the service brakes by using pres- sure to slow the drivetrain. Use the service brakes for quick stops. With the exhaust brake switch ON, the engine exhaust brake automatically creates its braking effect when you remove your foot from the accelerator pedal and all other required conditions are met (see below). The brake switch is located on the switch panel between the seats.

It con- trols whether the brake is ON (ready to slow the vehicle down) or OFF (no brak- ing action). Make sure the exhaust brake switch is OFF before starting the engine. Exhaust Brake Operation