Stopping Driving With the vehicle stationary, apply the parking brake and place the shift lever in Neutral. Before stopping the engine, allow it to idle for one to two minutes. This will allow the following: An adequate oil supply to the turbo- charger bearings while the turbo- charger rotor assembly is cooling preventing the possibility of turbo- charger bearing failure. Prevention of excessive engine coolant temperatures. Turn the engine off by turning the igni- tion key to the OFF position. Then remove the key. Apply the parking brake with the park- ing brake lever. Check that all the win- dows and the roof vent are closed. Turn off the ignition and remove the key.
Then lock all the doors of the vehicle. WARNING! Do not remove the ignition key nor turn off the engine while the vehicle is in motion. Failure to observe this precaution can result in st eering lock engagement. Turning off the engine When the vehicle is parked on a grade, one or more of the following precau- tions should also be taken: Chock the wheels at front and rear. NOTE: Suitable wheel chocks are at a minimum an 18-inch (46 cm) long 4x4. Angle the front wheels so that the vehicle will not move into the traffic stream if it is accidentally set in motion. Stopping Parking