20 TESTING AND ADJUSTING Standard value table for engine related parts ............................................................ 20- 2 Standard table for chassis related parts..... 20- 3 Standard table for electrical parts............... 20- 13 Tool for testing, adjusting, and troubleshooting ............................................ 20- 22 Measuring engine speed ............................ 20- 23 Measuring exhaust gas color...................... 20- 24 Adjusting valve clearance ........................... 20- 25 Measuring blow-by pressure....................... 20- 26 Testing and adjusting fuel injection timing . 20- 27 Measuring engine oil pressure ...................
20- 28 Adjusting engine speed sensor .................. 20- 29 Adjusting governor motor lever stroke........ 20- 30 Testing and adjusting hydraulic pressure in work equipment, swing, travel circuit...... 20- 31 Testing and adjusting PC valve output pressure (servo piston input pressure) ....... 20- 34 Testing and adjusting LS valve output pressure (servo piston input pressure) and LS differential ....................................... 20- 36 Testing and adjusting control pump circuit oil pressure ................................................. 20- 39 Testing solenoid valve output pressure ...... 20- 41 Measuring PPC valve output pressure .......
20- 42 Adjusting work equipment, swing PPC valve ............................................................ 20- 43 Testing travel deviation ............................... 20- 44 Testing locations causing hydraulic drift of work equipment ...................................... 20- 45 Measuring oil leakage ................................. 20- 46 Releasing remaining pressure in hydraulic circuit ........................................... 20- 48 Testing clearance of swing circle bearing .. 20- 49 Testing and adjusting track shoe tension ... 20- 50 Bleeding air ................................................. 20- 51 Troubleshooting...........................................
20-101 fl Note the following when making judgements using the standard value tables for testing, adjusting, or troubleshooting. 1. The standard value for a new machine given in the table is the value used when shipping the machine from the factory and is given for reference. It is used as a guideline for judging the progress of wear after the machine has been operated, and as a reference value when carrying out repairs. 2. The service limit value given in the tables is the estimated value for the shipped machine based on the results of various tests. It is used for reference together with the state of repair and the history of operation to judge if there is a failure. 3.
These standard values are not the standards used in dealing with claims. ¤ When carrying out testing, adjusting, or troubleshooting, park the machine on level ground, insert the safety pins, and use blocks to prevent the machine from moving. ¤ When carrying out work together with other workers, always use signals and do not let unauthorized people near the machine. ¤ When checking the water level, always wait for the water to cool down. If the radiator cap is removed when the water is still hot, the water will spurt out and cause burns. ¤ Be careful not to get caught in the fan, fan belt or other rotating parts. 20-1