Cummins — TIMING TOOL INSTALLATION

Engine Assembly (00-02) Injection Timing - General Information N14 Page 0-83 Align the plunger rod (1) and the injector push rod (3) with each other, and parallel to the plunger rod. NOTE: Tighten the clamp handle (2) after the plunger rod is aligned with the injector push rod. Loosen the support bracket (4) and slide the bracket down until the plunger rod (1) engages the injector push rod (3). NOTE: The support bracket must be aligned with the ver- tical line on the clamp handle bracket. The push rod (3) must be vertically aligned with the plunger rod (1). Compress the plunger rod tension spring approximately 12.7 mm [0.50-inch], and tighten the support bracket.

Determine the piston top dead center (TDC) on the com- pression stroke by rotating the crankshaft in the direction of engine rotation ( clockwise ) until the piston plunger reaches its uppermost position. NOTE: Use only the crankshaft to rotate the engine. The use of the gears will result in false measurements. Gear lash must be closed up in the direction of normal rotation (crank- shaft clockwise ).