Engine Assembly (00-02) Injection Timing - General Information N14 Page 0-85 Put the push rod travel dial indicator in the center of the injector push rod plunger. Lower the indicator to within 0.63 mm [0.025-inch] of fully compressed position, and tighten the thumbscrew to hold the indicator in position. Set the dial indicator at ‘‘0’’ (zero). Lock the indicator face with the thumbscrew. Rotate the crankshaft in the opposite direction of engine rotation ( counterclockwise ) through TDC to 45 degrees before top dead center (BTDC). NOTE: This step is necessary to remove the gear train lash and to provide more accurate indicator readings.
Observe the dial indicator readings prior to crankshaft rotation to assist in later determining BTDC piston setting and timing reading. NOTE: If the crankshaft is rotated beyond the -5.161 mm [-0.2032-inch] position, the crankshaft must be rotated coun- terclockwise back to 45 degrees BTDC. Repeat the follow- ing step. Rotate the crankshaft slowly in the direction of engine rotation ( clockwise ) until a reading of -5.161 mm [-0.2032- inch] BTDC is reached on the piston travel dial indicator.