Cummins — TIMING TOOL INSTALLATION

Injection Timing - General Information Engine Assembly (00-02) N14 Page 0-88 The accompanying chart lists the different cam follower housing gaskets, the gasket thickness, and approximate change in push rod travel at 19 degrees BTDC 0.2032- inch piston travel.

Change in Push Rod Travel At 19° BTDC [mm] Inch 3020000 (Print-O-Seal) 0.36 to 0.51 [0.014 to 0.020] 0.09 to 0.13 [0.0035 to 0.005] 3020001 0.15 to 0.20 [0.006 to 0.008] 0.04 to 0.05 [0.0015 to 0.002] 3020002 0.36 to 0.51 [0.014 to 0.020] 0.09 to 0.13 [0.0035 to 0.005] 3020003 0.51 to 0.61 [0.020 to 0.024] 0.13 to 0.15 [0.005 to 0.006] 3020004 0.69 to 0.84 [0.027 to 0.033] 0.18 to 0.20 [0.007 to 0.008] Cam Follower Housing Gaskets Gasket Part No. Thickness [mm] Inch NOTE: The Print-O-Seal gasket (1) must be against the cylinder block with the sealing bead toward the cam follower housing.

The minimum amount of gasket stack-up thickness which can be used is 0.43 mm [0.017-inch] (one Print-O-Seal gasket). The maximum gasket stack-up thickness allowed is 2.03 mm [0.080-inch]. If you can not correct the injection timing by increasing or decreasing the thickness of the cam follower housing gaskets (1), an offset camshaft key (2) must be installed. The timing code specifies the required camshaft key. An offset key can be required initially. After completing the injection timing check on cylinder No. 1, check the injection timing on cylinders No. 5 and No. 3.