Cummins — TIMING TOOL INSTALLATION

Engine Assembly (00-02) Injection Timing - General Information N14 Page 0-87 NOTE: The injection timing can be changed by removing the cam follower housing and by increasing or decreasing the gasket thickness. Each 0.18 mm [0.007-inch] of gasket thick- ness affects injection timing by approximately 0.05 mm [0.002-inch] indicator travel. NOTE: Gaskets are available in the following nominal thick- nesses: 1. 0.18 mm [0.007-inch]. 2. 0.43 mm [0.017-inch]. 3. 0.43 mm [0.017-inch] (Print-O-Seal*). 4. 0.56 mm [0.022-inch]. 5. 0.76 mm [0.030-inch]. *One Print-O-Seal gasket must be used for each cam follower housing. Increase the gasket thickness to advance the injection timing (Add = Advance).

Decrease the gasket thickness to retard the injection timing (Remove = Retard).