Accessory Drive - Installation Engine Assembly (00-02) N14 Page 0-90 Use a dial indicator to check the backlash between the accessory drive gear and the camshaft gear. Install the tip of the dial indicator against a tooth on the accessory drive gear as shown. Push the accessory drive gear against the accessory drive thrust washer or thrust face. Hold the gear against the thrust washer or thrust face when checking the backlash. Turn the accessory drive gear by hand as far as it will freely move, and set the dial indicator to (zero). Turn the accessory drive gear by hand in the opposite direction as far as it will freely move, and read the dial indicator.
Backlash Between the Accessory Drive and the Camshaft Gear mm in 0.05 MIN 0.002 0.50 MAX 0.020 If the backlash is not within specifications, the gear must be replaced.