Engine Assembly (00-02) CELECT™Engine Position Sensor (EPS) - Installation N14 Page 0-91 CELECT™Engine Position Sensor (EPS) - Installation Install a new EPS in the mounting hole in the block. Make sure a new o-ring is present and in place. Use service tool, Part No. 3822747. Tighten the EPS. Torque Value: 34 [25 ft-lb] Lubricating Oil Pump - Installation Install a new gasket on the mounting trunion of the lu- bricating oil pump. Install the lubricating oil pump in the mounting hole in the cylinder block gear flange. Install and tighten the five mounting capscrews. Torque Value: 54 [40 ft-lb] Use a dial indicator to check the backlash between the lubricating oil pump and the camshaft gear.
Install the tip of the dial indicator against a tooth on the lubricating oil pump drive gear as shown.