Cummins — GEAR COVER - INSTALLATION

Gear Cover - Installation Engine Assembly (00-02) N14 Page 0-92 Turn the lubricating oil pump drive gear by hand as far as it will freely move, and set the dial indicator to ‘‘0’’ (zero). Turn the lubricating oil pump drive gear by hand in the opposite direction as far as it will freely move, and read the dial indicator. Backlash Between the Lubricating Oil Pump Drive Gear and the Camshaft Gear mm in 0.05 MIN 0.002 0.50 MAX 0.020 If the backlash is not within specifications, the lubricating oil pump drive gear must be replaced. Gear Cover - Installation Install one 7/16-20 X 4-inch guide stud in each side of the gear cover mounting flange to align the cover.

Install the gear cover gasket over the guide studs and the dowel pins. NOTE: Use a film of Lubriplate T 105 or its equivalent or grease to hold the gear cover gasket in place, if necessary. Install the gear cover. Install and tighten the mounting capscrews in the sequence shown. Torque Value: 68 [50 ft-lb]