Cummins — GEAR COVER - INSTALLATION

Engine Assembly (00-02) Gear Cover - Installation N14 Page 0-93 Cut off the ends of the gasket even with the cylinder block oil pan mounting flange. Mount a dial indicator on the front face of the crankshaft. Put the indicator plunger against the oil seal bore, and set the dial indicator to (zero). Rotate the crankshaft one complete revolution while mon- itoring the indicator. The total indicator reading must not exceed 0.38 mm [0.015-inch]. If the total indicator runout exceeds 0.38 mm [0.015- inch], remove the gear cover. Check the cover and the housing for nicks or burrs. Clean the gear cover and the housing surfaces thoroughly.

Repeat the gear cover installation procedure, and check the total indicator runout again. If the total indicator read- out is not within specifications, the gear cover must be replaced.