Cummins — ROCKER LEVER HOUSING - INSTALLATION

Lubricating Oil Pan - Installation Engine Assembly (00-02) N14 Page 0-98 Lubricating Oil Pan - Installation Install the oil pan gasket and the oil pan on the cylinder block. Use your fingers to install and tighten one of the 7/16-inch oil pan mounting capscrews on each side of the oil pan, halfway between the front and the rear of the oil pan. Use your fingers to install and tighten all the mount- ing capscrews. Tighten the four 5/16-inch capscrews in the rear of the oil pan in the sequence shown. Torque Value: 27 [20 ft-lb] Tighten the thirty-two (32) 7/16-inch capscrews in the sequence shown. Torque Value:

68 [50 ft-lb] Fuel Crossovers - Installation Use new o-rings, and install the two fuel crossover con- nections and the two cover plates. Tighten the capscrews. Torque Value: 4.0 [35 in-lb] Rocker Lever Housing - Installation Install two o-rings (1) on each of the two water tubes (2). Install one o-ring (1) on each of the two water plugs (3). Apply a non-petroleum based lubricant such as soap or vegetable oil to the o-rings on the tubes and the plugs and to the bores in the rocker housing.