Cummins — CELECT ENGINES

Engine Assembly (00-02) Injector and Valve Adjustment N14 Page 0-105 Make sure the push rods are in the cam follower sockets, and align the push rods with the injector and valve rocker lever adjusting screws. Alternately tighten the rocker shaft capscrews in 54 N•m [40 ft-lb] increments to 156 [115 ft-lb]. Injector and Valve Adjustment CELECT™Engines The valve set marks are located on the accessory drive pulley. The marks align with a pointer on the gear cover. Use the accessory drive shaft to rotate the crankshaft. The crankshaft rotation is clockwise when viewed from the front of the engine. The cylinders are numbered from the front end of the engine.

The engine firing order is 1-5-3-6-2-4. All overhead (valve and injector) adjustments must be made when the engine is cold (any stabilized coolant temperature at 60°C [140°F] or below). Each cylinder has three rocker levers. The rocker lever nearest to the center of the housing is the intake lever. The exhaust rocker lever (1). The injector rocker lever (2). The intake rocker lever (3). The two levers closest to the center of each rocker hous- ing are the intake rocker levers. The two levers closest to the ends of the rocker housing are the exhaust levers.