Cummins — ROCKER LEVER SHAFT ASSEMBLIES - INSTALLATION

Rocker Lever Shaft Assemblies - Installation Engine Assembly (00-02) N14 Page 0-104 Use a wire gauge to check the clearance between the crosshead and the valve spring retainer. The clearance must be a minimum of 0.51 mm [0.020-inch]. NOTE: The large pocket goes toward the exhaust side. Rocker Lever Shaft Assemblies - Installation Install the exhaust (1), injector (2), and intake (3) rocker levers onto the shaft. The two levers closest to the center of the rocker housing are the intake valve rocker levers. The levers closest to the end of the rocker housing are the exhaust valve rocker levers. Caution:

If the adjusting screws protrude beyond the maximum listed below, the push rods can be damaged when the rocker lever shaft capscrews are tightened. Do not attempt to install the rocker lever shaft assemblies without resetting the lash. Loosen the rocker lever adjusting screws so there is a maximum of 32 mm [1.250 inches] from the top surface of the lever and the ball end of the adjusting screw. Put the rocker lever assembly over the dowel pin and dowel ring located in the rocker housing. NOTE: Do not damage the dowel pin and ring located in the rocker housing.