Cummins — CELECT ENGINES

Engine Assembly (00-02) Injector and Valve Adjustment N14 Page 0-107 Tighten the adjusting screw on the injector rocker lever. Torque Value: 2.8 [25 in-lb] Caution: After preloading the CELECT™injector to 2.8 [25 in-lb], make sure to back out the adjusting screw two flats (120 degrees) or damage to the injector will result. Back out the adjusting screw on the injector rocker lever two flats (120 degrees). NOTE: Two flats will provide 0.63 mm [0.025 inch] lash. The specification is 0.50 to 0.74 mm [0.020 to 0.029 inch] lash. Hold the adjusting screw and tighten the lock nut. Torque Value: 68 [50 ft-lb] After setting the injector on a given cylinder, set the valves on the same cylinder.

With the ‘‘A’’ set mark aligned with the pointer on the gear cover and both valves closed on cylinder No. 1, loosen the lock nuts on the intake and the exhaust valve adjust- ing screws.